Urgent help required!

After finding out that RIP isn’t hip anymore we at DERPCORP have decided to migrate to an open standard routing protocol! After googling for literally seconds we found an article published on April 1 saying that EIGRP is a open standard so we have adopted it immediately…since /u/the-packet-thrower was still in his “blackout nap” after celebrating his shiny new VCP.

We asked the nice folks at /r/computertechs for advice but unfortunately things aren’t quite working for some reason.

Notes & Rules & Stuff

This lab was made with the c7200-adventerprisek9-mz.152-4.S5 image so for best results you should be running something similar.

The hosts in the lab are just 7200 routers with routing disabled and dhcp set on the interface. I debated using thin VMs etc but ultimately decided that it would be easier for those without strong GNS3 skills but no harm in swamping them out for 3600 routers or VMs.

Once again, this is for fun so try to refrain from posting answers but discussion should be fine, also try to fix any issues rather than just remove the feature.

This lab has a fair amount of cool stuff that is above the CCNA level (DMVPN, DHCP, NTP, IPv6) that one might see in the real world though the faults should be fair enough for you guys to give it the old college try.

THERE BE ISSUES:

1. The hosts don’t seem to be getting DHCP addresses
2. We heard that EIGRP is supposed to load balance non equal paths but that doesn’t seem to be working on the FW-Main1 links
3. Hosts can’t seem to get to www.derpcorp.com (10.111.111.111), fix it! fix it! fix it!

Here’s the link for the lab HERE